Input And Output Module

Product Details:

Output Relay Module, Notifier: FRM-1 provides the system with a dry-contact output for activating a variety of auxiliary devices, such as fans, dampers, control equipment, etc. Addressability allows the dry contact to be activated, either manually or through panel programming, on a select basis.

Additional Information:

• Item Code: FRM-1
• Delivery Time: 5 to 6 Weeks

Product Details:

Analoge Input Module, Notifier: FMM-4-20 allows the NFS2-3030 fire alarm control panel (FACP) to monitor industry-standard, linear-scale, 4–20 mA protocol sensors. The module converts the sensor output to communication protocol that can be interpreted by the FACP for monitoring and display. There are numerous sensors available in the marketplace that communicate using a 4–20 mA output, including gas sensors, temperature sensors, air speed sensors, and more.

Features of Analoge Input Module, Notifier: FMM-4-20:

• SEMS screws for easing wiring
• Panel controlled status LED (bi-color)
• Analog communications
• Rotary address switches
• Low standby current
• Mounts in standard 4" (10.16 cm) junction box
• FlashScan® operation

The FMM-4-20 Module includes numerous safeguards and protective features to ensure trouble-free operation. The external power supply is isolated from the communication line. In addition, a 500 mA current limiter and a cutoff circuit protect the module’s electrical supply from short circuits. In the event of a short, the output voltage will cycle within safe limits until the short is removed. The output signal is sampled and filtered for transients and noise prior to passing the signal along to the FACP. If the current running through the sensing circuitry exceeds 25 mA, the output voltage will shut down and theshort protection process will begin. The module accepts both 3-wire (device sink) and 2-wire configurations.

Additional Information:

• Item Code: FMM-4-20
• Delivery Time: 8 to 9 Weeks

Product Details:

Mini Monitor Module, Notifier: FMM-101 uses one of the available module addresses on an SLC loop. It responds to regular polls fromthe control panel and reports its type and the status (open/ normal/short) of its Initiating Device Circuit (IDC).

• Built-in type identification automatically identifies this device as a monitor module to the panel.
• Powered directly by two-wire SLC loop. No additional power required.
• High noise (EMF/RFI) immunity.
• Tinned, stripped leads for ease of wiring.
• Direct-dial entry of address: 01 – 159 on FlashScan loops; 01 – 99 on CLIP loops.

Additional Information:

• Item Code: FMM-101
• Delivery Time: 5 to 6 Weeks